5
193
Starting and Driving
When pressing the D/M (Drive/Manual)
button or both paddles, the rear
camera mode is exited and the
navigation or audio screen appears
again.
When displayed, dynamic grid lines (if
the function is set to MIA through the
"Settings" menu of the "Vehicle"
page) will illustrate the width of
the vehicle to assist with parking
or aligning to a hitch/receiver. The
dynamic grid lines will show separate
zones in different color that will help
indicate the distance to the rear of the
vehicle.
The following table shows the
approximate distances for each zone
and color:
Zone
Distance to the rear of the
vehicle
Red 11 - 12 in (28 - 30 cm)
Yellow 12 - 78 in (30 cm - 2 m)
Green 78 - 118 in (2 -3 m)
WARNING!
Drivers must be careful when
reversing even when using the rear
view camera. Always check carefully
behind your vehicle, and be sure to
check for pedestrians, animals, other
vehicles, obstructions, or blind spots
before reversing. You are responsible
for the safety of your surroundings
and must continue to be careful while
reversing. Failure to do so can result in
serious injury or death.
CAUTION!
•
To avoid vehicle damage, the rear
camera should only be used as a
parking aid, as the rear camera is
unable to view every obstacle or
object in your drive path.
•
To avoid vehicle damage, the vehicle
must be driven slowly when using
the rear camera to be able to stop in
time when an obstacle is seen. It is
recommended that the driver looks
frequently over his/her shoulder
when using the rear camera.
NOTE:
If snow, ice, mud, or any other
substance builds up on the camera
lens, clean the lens, rinse with water,
and dry with a soft cloth. Do not cover
the lens.
To Next Page
Loading...
Need help?
General
