5
194
Starting and Driving
Cruise Control (CC)
Using the controls located on the left
side of the steering wheel, the driver
can maintain a constant cruise control
(CC function) speed, without operating
the accelerator pedal.
The CC enables the driver to maintain
the desired vehicle speed without
pressing the accelerator pedal,
reducing driving fatigue on highways,
especially long trips, as the set speed
is automatically maintained. A firm
press on the accelerator pedal or
the braking pedal will temporarily
deactivate the cruise control function.
CAUTION!
The device can only be switched on at
speeds exceeding 18 MPH (30 km/h)
and it switches off automatically when
the brake pedal or the accelerator
pedal is pressed.
WARNING!
The Cruise Control function must only
be activated when traffic and the
route permit a constant speed to be
maintained safely for a sufficiently
long distance.
Controls
The controls are located on the left
side of the steering wheel with a
specific button to enable and disable
the CC.
Control buttons have the following
functions:
Multifunction switch:
• ON/OFF button to en-
gage/disengage CC sys-
tem.
• Pushed (indication CANC)
deletes the set speed.
Multifunction switch:
• Press up (indication RES
+): increase speed, set
current speed or resume
previously set speed when
system is in "cancelled"
status;
• Press down (indication
SET -): set speed/decrease
speed.
Displayed Information
Apart from the pop-up messages at
the center of the display, CC system
status is represented by icons in the
dedicated area, depending on the
drive mode selection activated, except
in CORSA mode where this function is
not available. See "Instrument Cluster
Overview" in section "Instruments and
Controls".
Displayed information depends on
system status: ready, set, temporarily
cancelled or override.
Activation
To turn the system on, push the
CANC button. The white light with
below 3 dashes on the cluster display
will illuminate.
To Next Page
Loading...
Need help?
General
