5
196
Starting and Driving
white light with below the set speed
will appear on the cluster display.
Driver Override
If the driver presses the accelerator
pedal while the CC is on, such as to
overtake another vehicle, and exceeds
the set speed limit, the system will
temporarily deactivate the CC.
When the accelerator pedal is
released, the vehicle will return to the
set speed.
Resume Speed
To resume a previously set speed, push
upward the multifunction switch
(RES +) and release. The green
light with below the set speed will
illuminate on the cluster display.
Resume can be used at any speed
above 18 MPH (30 km/h).
Using Cruise Control on
Hillsides
The transmission may be downshifted
on hills to maintain the vehicle set
speed. The CC system maintains set
speed up and down hills. A slight
speed change on moderate hills is
normal. On steep slopes, a greater
speed loss or gain may occur so we
recommend to drive without CC.
WARNING!
Cruise Control (CC) can be dangerous
where the system cannot maintain a
constant speed. Your vehicle could
go too fast for the conditions, and
you could lose control and have an
accident. Do not use CC in heavy
traffic or on winding, icy, snow-
covered or slippery roads.
Blind Spot Assist - BSA ( )
System Operation
The Blind Spot Assist (BSA) system
uses two radar-based sensors, located
inside the rear bumper fascia, to
detect highway licensable vehicles
(cars, lorries, motorbikes, etc.) that
enter the blind spot zones from
the rear/front/side of the vehicle in
adjacent lines.
The example shown in the figure
highlights the blind spots on either
side of the vehicle when overtaking
traffic is approaching from behind.
When the vehicle is started, the BSA
warning light will momentarily
illuminate in both outside rear view
mirrors to let the driver know that
the system is operational and on. The
BSA system sensors operate when
the vehicle is in any forward gear
To Next Page
Loading...
Need help?
General
