Massimo MSU 700 - Page 140

Periodic Maintenance and Adjustment 8-42
by lifting it up and pulling it out.
1. Battery compartment cover
2. Turn the key to “OFF” and turn off the
electrical circuit in question.
CAUTION:
To prevent accidental short-circuiting, turn off
the main switch when checking or replacing
a fuse.
3. Remove the blown fuse, and then install
a new fuse of the specified amperage.
Specified fuses:
Main fuse
Headlight fuse
Speedometer ECU normally
energized fuse
Stop lamp fuse
Turn lamp fuse
Gear switch fuse
EPS fuse
Fuel pump fuse
Reverse gear fuse
Auxiliary DC jack fuse
ECU fuse
Speedometer unit fuse
Four-wheel drive fuse
30.0A
15.0A
5.0A
10.0A
10.0A
10.0A
10.0A
15.0A
10.0A
15.0A
15.0A
15.0A
15.0A
4. Turn the key to “ON” and turn on the
electrical circuit in question to check if
the device operates.
5. If the fuse immediately blows again, have
a service center check the electrical