Periodic Maintenance and Adjustment 8-46
turning it clockwise.
8. Install the bulb holder cover and the
cover at the rear of the headlight.
CAUTION:
Make sure the headlight bulb holder cover is
securely fitted over the bulb holder and
seated properly.
9. Close the hood.
10. Adjust the headlight beam if necessary.
Headlight beam adjustment
CAUTION:
It is advisable to have a service center make
this adjustment.
To raise the beam, turn the adjusting screw in
direction
。
To lower the beam, turn the adjusting screw
in direction
.
1. Headlight beam adjusting screw
Tail/brake light bulb replacement
If a tail/brake light bulb burns out, replace it
as follows:
1. Remove panel A (if replacing the left
tail/brake bulb) or panel B (if replacing
the right tail/brake bulb) by removing the
quick fasteners and bolts.
To Next Page
Loading...
