Operation 6-5
1. Drive select lever
3. Release the brakes and press the
accelerator pedal gradually.
Shifting: Neutral to Reverse
1. Stop the vehicle. Keep your foot off the
accelerator pedal.
2. Apply the brake pedal.
3. Shift from neutral to reverse or vice versa
by moving the drive select lever along
the shift guide.
NOTE:
● Please kick the brake pedal first, before place
gearshifts lever to“reverse”position.
● In the brake pedal, there is a cable, which is
connected to a position pin located on the
gearshift assembly. Only when the brake pedal
is depressed, the position pin will be retracked,
and gearshifts can be removed to “reverse”
position.
1.Position pin 2.Cadle 3. Adjust
6-4 Operation
and the vehicle can been ridden.
Otherwise, go on with the third step.
3. Continue warming up the engine until it
idles smoothly.
CAUTION:
See the “Engine break-in” section prior to
operating the engine for the first time.
Drive Select Lever Operation and
Driving In Reverse
CAUTION:
Before shifting, you must stop the UTV and
return the throttle lever to the closed position;
otherwise the transmission may be
damaged.
Shifting: Neutral to High and High to Low
1. Stop the vehicle. Keep your foot off the
accelerator pedal.
2. Apply the brakes, and then shift by
moving the drive select lever along the
shift guide.
NOTE:
Make sure that the drive select lever is
completely shifted into position.
To Next Page
Loading...
