Mastech MS5201 - Test Leads and Test Clips Replacement

33
33
5.1.2 Loosen the screw fixing the battery cover and remove it.
5.1.3 Replace the exhausted battery with a new one.
5.1.4 Put the battery cover as its origin.
5.2 TEST LEADS AND TEST CLIPS REPLACEMENT
WARNING
Full in compliance with safety standards can be guaranteed only if
used with test leads or test clips supplied. If necessary, they must
be replaced with the same model or same electric ratings. Electric
ratings of the test leads or test clips: 1000V 5A
You must replace the test leads or test clips if the lead is exposed.