Mastech MS8218 - Page 11

MS8218 True RMS Multimeter
Introduction to the Meter
LCD screen is shown as in Figure 2-2, with its every symbol's meaning shown as in the Table 1:
Number of Order Symbol Functions
1
DC OF
Indicating the measurement unit being 'c or of of temperature
1
mnF
Indicating the measurement unit being µ F or nF of Capacitance
1
milA
Indicating the measurement unit being
µ A,rnA or A of current
1 dBmV
Indicating the measurement unit being dBm of power or m V and V of voltage
1
MKOHz
Indicating the measurement unit being M Q ,K Q and
Q
of resistance or
MHz, KHz and Hz of frequency
2
flex
Indicating the measurement unit being the duty ratio of logic impulse
3
MAX-MIN
Indicating the display value being the maximum value(MAX),the minimum
value(MIN) or the maximum value-the minimum value(MAX-MIN)
4
AUTO
Indicating the measurement being automatic range
S
MANUAL
Indicating the measurement being manual range
6
51000
Indicator of range, indicating the full range value of this range in manual
range such as S, SO, SOO and 1000,SOOO, etc.
7
~
Indication to low voltage of the batteries, showing the energy of batteries will
be exhausted soon
8
a
Indicating the measurement being relative measurement while the displayed
value being relative value
9
.) l)
Indicating it is now performing the continuity measurement
9