14
MASTER CHEF
®
12˝ TABLETOP GAS PIZZA OVEN
LEAK TEST
LEAK TEST— BEFORE YOU BEGIN
Before each use, check all the gas connections for leaks using the procedure listed below.
1. Make a solution of one part liquid detergent and one part water. You will need a
spray bottle, brush or rag to apply the solution to the fittings.
2. The pizza oven control knob must be set to OFF/“0”.
3. Ensure that the regulator is connected to the LP cylinder.
Hand tighten only.
4. Spray the gas valve, hose and regulator and the top of the LP cylinder to check
for leaks (see image A and B).
5. Slowly open the LP cylinder counter-clockwise. If bubbles are visible (see image
C), immediately turn the gas supply OFF, tighten fittings and test again.
6. If no bubbles appear, proceed with lighting instructions.
WARNING: If the smell of gas is detected at any time, immediately set the control knob to
OFF/“0”, close the LP cylinder and perform a leak test.
A
C
B
To Next Page
Loading...
