30
Cooking Guide
Rib Hanger
• To cook ribs, a rib hanger is required. Just hang the ribs by the hanger and at the top of the basket.
Product no. 085-3250-4 (TF2201804-MC) |
Contact us: 1-855-803-9313
Rib Hanger
Rib Hanger
On top
Troubleshooting
Problem Possible Cause Corrective Action
1. LP cylinder fuel is used up.
2. Bad electrode spark.
3. Burner may not be properly seated.
4. Burner may be obstructed.
5. Cylinder valve may be closed.
6. Regulator is not properly seated on
cylinder valve.
7. Wire and/or electrode covered with
cooking residue.
Burner will not
light
1. Change a new full LP cylinder.
2. Check to see if the burner will light using a match. Electrode may
need adjusting. Distance between tip of electrode and gas port
should be 1/8” to 1/4”.
3. Refer to section “To Reinstall The Burner” on P.23 to reinstall
burner properly.
4. Refer to section “Burner Cleaning” on P.23 to clean the burner.
5. Check then open the cylinder valve.
6. Refer to section “Connection Procedures” on P.17 to reinstall
regulator properly.
7. Clean wire and/or electrode with rubbing alcohol and clean swab.
Fire at control
knob
1. Burner is improperly seated on
control valve.
2. Gas connections may be loose.
3. Burner holes may be obstructed.
1. Refer to section “To Reinstall The Burner” on P.23 to reinstall
burner properly.
2. Refer to the section “Leak Testing” on P.18 to check and
tighten all connections.
3. Refer to section “Burner Cleaning” on P.23 to clean the burner.
To Next Page
Loading...
Need help?
General
