33
Saw does not make
accurate 90º or 45º
cuts
Positive stops inside the
cabinet need adjusting
(Bevel cuts)
Adjust the positive stops
Mitre gauge is misaligned
(Mitre Cuts)
Adjust the mitre gauge
Height/bevel-
adjusting hand
wheel is hard to
turn.
Gear and screw post
inside the cabinet are
clogged with sawdust.
Clean the gear and screw
post.
Saw does not start
Motor cord or wall cord is
not plugged in.
Plug in motor cord or
wall cord
Circuit fuse is blown
Replace the circuit
breaker
Circuit breaker is tripped Reset the circuit breaker
Circuit switch is damaged
Have the cord or switch
replaced by a qualified
service technician.
Blade makes poor
cuts
Blade is dull or dirty
Clean, sharpen or replace
the blade
Blade is the wrong type
for cut being made
Replace with the proper
type
Blade is mounted
backwards
Remount the blade
Blade does not
lower when turning
the Height/bevel-
adjusting hand
wheel
Locking lever is not at full
left position
Move the locking lever to
the left
To Next Page
Loading...
