MasterCraft csx 220 User Manual

The following checks and services are essential to safe boating
and must be performed. Get in the habit of performing these checks
in the same order each outing so that it becomes routine.
DO NOT launch or operate the boat if any problem is found
during the Safety Check. A problem could lead to an acci-
dent during the outing, resulting in death or serious injury.
Any and all problems should receive attention immediately.
See your authorized MasterCraft dealer’s service depart-
ment for assistance.
Before Each Operation
These tasks are best accomplished before the boat is launched.
• Follow all engine and drive train pre-operation maintenance and
safety checks as outlined in the engine owner’s manual provided.
• Check the weather report, wind and water conditions.
• Check for recommended on-board tools and parts.
• Check that all drain plugs are installed properly, including bilge and
rear drain.
• Check the propeller and shaft for damage.
• Check that there is an adequate supply of fuel.
• Check that the steering system operates properly.
• Check that required safety equipment is on board.
• Check that the windshield and extrusions do not show any
damage.
When boating, avoid using the windshield as an aid for
balance or getting out of a seat. is causes undue stress
to the window frame and could damage it, which may
not be covered under warranty.
sa fet y c h ecks and s erv i ces
• Checkthatthereextinguisherisfullycharged.
• Check that no fuel, oil or water is leaking or has leaked into the
bilge compartment.
• Check all hoses and connections for leakage or damage.
• Check that all required
Scheduled Maintenance Checks and
Services (see following sections) were performed.
During Operation
• Check gauges frequently for operating conditions.
• Pay attention that controls operate smoothly.
• Note any excessive vibration.
After Operation
• Checkforuidleaks.
• In boats equipped with a ballast system, drain water from the bal-
last system before placing the boat on the trailer. If the boat has
ballast-pumping assistance to remove water from the ballast sys-
tem, note that the engine must be running at least 1500 RPM dur-
ingthepumpingprocess(forbothllandemptyoperations).This
will necessitate draining water prior to ceasing operation of the
boat and loading on the trailer. More information regarding ballast
systems appears in various sections of this Owner’s Manual.
• Checkthens(whereequipped),propeller,rudderandshaftfor
damage after removing the boat from the water.
mastercraft 2010 ow n e r ’s m anual • page 8-1

MasterCraft csx 220 Specifications

General

Brand	MasterCraft
Model	csx 220
Category	Boat
Language	English