Matrix Audio Designs
23
Step-by-Step Programming of Special Keys
Step 1. Enter Programming Mode: Press the button on the MRC-8e/ 8.4e marked program.
The red LED above the program button will light up.
Step 2. Select a Source: Press the source buttons on the left side of the panel you wish to con-
figure.The LED beside the source you have selected will light,and the LEARN/ ERROR light
will begin to flash RED slowly.
Step 3. Send the signal from the remote: Press or tap the“Play”button on the remote control.
Good signal,you may proceed to step 4.Bad signal go back to step 2.
Step 4. Press the ON/ OFF button on the MRC- 8e/ 8.4e programming keypad (always the top
row 2nd key from the left).This will get you ready for the ON Command.
Press or tap the“POWER ON”button the remote control.Good signal: Proceed to 5.
Bad Signal: Start Step 4 over again.
Step 5. Press the ON/ OFF button again for the OFF Command.
Press or tap the“POWER OFF”button on the remote.If it’s the same key on the remote,store
that code in again.Good signal: Proceed to Step 6.
Bad Signal: Start step 5 over again.
Step 6. Press the Program key to exit programming mode.The program light will go out.
Step 7. Test your program.When you’re not in programming mode,the programming panel
functions just like a regular keypad and zone (but without the speakers).
If all your audio equipment is hooked up and turned on when you press the unit select
button,the source you programmed should start playing.
If the source unit is powered off,the ON button will toggle the source power button.
Make sure the on/ off function works and when you’re done leave the device on,and then
press the unit select button.The device should start playing again.
To Next Page
Loading...
