Matrix Audio MRC-8e - Step-By-Step Program for Basic; Advanced Commands

Matrix Audio Designs
25
Step-by-Step Program for Basic / Advanced Commands
Step 1. Enter Programming Mode: Press the button on the MRC-8e/ 8.4e marked program.
The red LED above the program button will light up.
Step 2. Select a Source: Press the source buttons on the left side of the panel for the device you
wish to program.The LED beside the source you have selected will light,and the LEARN/
ERROR light will begin to flash RED slowly.
Step 3. Select the function key on the programming keypad you wish to program.
Step 4. Press or tap the associated button on the sources remote control.Good signal, you may
proceed to step 5.Bad signal,go back to step 3.
Step 5. Do you have any more keys to program for this source?
YES – Go to Step 3. NO - Go to step 6.
Step 6. Press the Program key to exit programming mode.The program light will go out.
Step 7. Test your program.
When you’re not in programming mode,the programming panel functions just like a regular
keypad and zone (but without the speakers).Ifall your audio equipment is hooked up and
turned on when you press the source select button,the source you programmed should start
playing.If the source unit is powered off,the ON button will toggle the source power
functions.
Press all of the keys that you programmed and observe the source equipment.
If it responds to the keypress,then the command is working correctly.
If it does not behave as expected,make a note of that key, and reprogram it again and re-test.