34
8.4 ERROR CODE TROUBLESHOOTING - 01AC
ERROR CODE 01AC
1) SYMPTOM:
a. 01AC - Electro magnet over current.
2) SOLUTION:
a. On standby mode, measure the resistance on ECB1 and ECB2 (Figure A). There should be 13.5 (+/- 5) ohms.
- If the ECB resistance is over the range, replace the ECB.
- If the ECB resistance is under the range, replace the LCB.
b. On workout mode, check the gapping of ECB1 and ECB2 (Figure B). There should be a gap of under .5mm between the ECB and
flywheel.
- Try to adjust the gap if possible.
- If the gap is over the range, replace the ECB.
- If the gap is under the range, replace the LCB.
FIGURE A FIGURE B
CHAPTER 8: TROUBLESHOOTING
To Next Page
Loading...
