183
182
11.3 SOFTWARE UPGRADE PROCEDURE FOR LCB - CONTINUED
5) The screen will show every software install status (Figure G). When the update is completed, turn off the machine and wait 30 sec, then turn
on the machine (Figure H).
6) From the welcome display, enter service mode by pressing ENTER, 3, 0, 0, 1, ENTER and press the General key on the screen. Then check
if the software version is right (Figure I)
FIGURE HFIGURE G
FIGURE I
CHAPTER 11: SOFTWARE UPGRADE INSTRUCTIONS
NOTES
To Next Page
Loading...
