Matrix ETERNITY NE Quick Start 23
Setting up the Voice Mail System
To complete the installation of the Voice Mail System (VMS), all you need to do is:
• connect a computer to the Ethernet Port of ETERNITY NE using the RJ45 cable supplied for
the port.
• open a Web browser on the computer to access the embedded web-server, Jeeves.
• activate the VMS License. For instructions, see “Activating License Key”.
Powering on ETERNITY NE
• Check the mains voltage at the power plug from where the power supply is to be fed to the
system. It should be as per the specifications mentioned in the “Product Specifications” in the
System Manual.
• Make sure system’s earthing is proper.
• Connect the Power Adapter into the power jack, and plug it into a power outlet.
• Switch ON the power supply and observe the reset cycle.
LED Indication
• At Power ON, Power LED will turn ON (Continuous Green).
• System LED (STS) will display following error/events/status:
• Mobile Ports take about 3 minutes to get registered with the network.
You may now access the web-based programming tool, Jeeves, and configure ETERNITY NE.
LED Status Color Comment
1sec On - 1sec Off (Continuous) Green ETERNITY NE started successfully.
5sec On - 5sec Off (Continuous) Green
Software Mismatch (uboot checksum
did not match)
10sec On - 10sec Off (Continuous) Green Flash Lock due to License
100msec ON - 100msec OFF - 100msec ON -
100msec OFF - 100msec ON - 5000msec OFF
Green
Recovery Mode
a
a. If you get Recovery Mode LED status, contact Matrix Support Team.
To Next Page
Loading...
