Matrix ETERNITY NE - VoIP Network Configuration

Matrix ETERNITY NE Quick Start 9
• change the SIM PIN to 1234 (this is the default PIN for both SIM Cards used in the
system). You can change this SIM PIN later from the Jeeves of ETERNITY NE when
configuring the Mobile Port.
• remove the SIM Card from the mobile handset.
If you do not want to use PIN protection, insert the SIM in the mobile handset and disable PIN
protection. Remove the SIM Card from the mobile handset and insert it in the Mobile Port of
ETERNITY NE.
Inserting SIM Card in the Mobile Port
• To insert the SIM Card in ETERNITY NE,
• insert the SIM into the SIM slot, with its contact side facing up.
• push the SIM backwards into the slot. The SIM is locked inside the slot.
• to unlock the SIM within the slot, push the protruded portion of the SIM backwards again.
• repeat the same steps to insert the other SIM Card.
• Connect the Antenna to the antenna connector.
• Switch On power supply, if you have finished connecting all the required ports.
• At every power on of the system, it takes about 3 minutes for the Mobile Ports to get
registered with the network. Once registration with the mobile network is completed, the
Mobile Port can be used.
The UMTS Mobile Ports of ETERNITY NE also provide Wireless WAN Interface. If you want to use
wireless WAN over the Mobile Port, you must have UMTS module installed in the system and
Internet services activated on the SIM.
VoIP Network
Before you connect the system to WAN, we recommend that you first connect a computer to the
Ethernet Port of ETERNITY NE, configure the Basic Settings, and then connect to WAN.
• You can connect ETERNITY NE to WAN either over Ethernet Port (Ethernet WAN) or over
Mobile Port 1 (Wireless WAN).
While several installation scenarios are possible, only three most common and most typical
scenarios are depicted here.