Matrix ETERNITY NE - Voip Module; Voice Mail System

Matrix ETERNITY NE Quick Start 7
VoIP Module
• Unpack the VoIP module.
• Make sure power supply is turned off before you begin installation.
• Unscrew and remove the top cover of the enclosure. Keep the screws and the cover aside.
• Locate the studs and connector of the VoIP module on the mainboard.
• Gently seat the VoIP module on the connector on the mainboard. The connector pins on the
module must make complete contact with those on the mainboard. Do not apply pressure.
• When the module is seated firmly on the connector on the mainboard, secure the module with
the screws on the studs.
• If you do not want to install any other module, replace the top cover and secure the cover with
the screws.
Voice Mail System
• The Voice Mail System (VMS) is supplied as a Pen Drive along with the system. However to
activate it, you must purchase the VMS License.
• Make sure power supply is turned off before you begin installation.
• Unscrew and remove the top cover of the enclosure. Keep the screws and the cover aside.
Studs for VoIP Module
on mainboard
Connector Pin for
VoIP module on
mainboard