MTX-ROUTER User Manual
Matrix Electronica S.L Page 25 of 87
Add： Alejandro Sanchez 109, 28019 Madrid. ESPAÑA
http：//www.mtx-terminals.com Tel：+34-91.560.27.37 Fax：+34+34-91.565.28.65
DDNS Status shows connection log information
3.3.1.3 Clone MAC Address
Some ISP need the users to register their MAC address. The users can clone the router MAC
address to their MAC address registered in ISP if they do not want to re-register their MAC
address
Clone MAC address can clone three parts: Clone LAN MAC, Clone WAN MAC, Clone Wireless
MAC.
Noted that one MAC address is 48 characteristic, can not be set to the multicast address, the first
byte must be even. And MAC address value of network bridge br0 is determined by the smaller
value of wireless MAC address and LAN port MAC address.
3.3.1.4 Advanced Router
Operating Mode: Gateway and Router
If the router is hosting users' Internet connection, select Gateway mode. If another router exists on
their network, select Router mode.
Dynamic Routing
Dynamic Routing enables the router to automatically adjust to physical changes in the network's
layout and exchange routing tables with other routers. The router determines the network packets’
route based on the fewest number of hops between the source and destination.
To enable the Dynamic Routing feature for the WAN side, select WAN. To enable this feature for
the LAN and wireless side, select LAN&WLAN. To enable the feature for both the WAN and
LAN, select Both. To disable the Dynamic Routing feature for all data transmissions, keep the
To Next Page
Loading...