Matrix MTX-ROUTER GPRS - Page 45

MTX-ROUTER User Manual
Matrix Electronica S.L Page 45 of 87
Add： Alejandro Sanchez 109, 28019 Madrid. ESPAÑA
http：//www.mtx-terminals.com Tel：+34-91.560.27.37 Fax：+34+34-91.565.28.65
PPPOE Server Inferface: PPPoE server interface to the outside, only to support the LAN port
Client IP(s): IP range assigns to the PPPoE client in the format: xxx.xxx.xxx.xxx-xxx
Deflate Compression: enable or disable Deflate Compression
BSD Compression: enable or disable BSD Compression
LZS Stac Compression: enable or disable LZS Stac Compression
MPPC Compression: enable or disable MPPC Compression
MPPE PPPoE Encryption: enable or disable MPPE PPPoE Encryption
Session Limit per MAC: default is 10
LCP Echo Interval: time interval to set the the LCP calibration phase response
LCP Echo Failure: release PPPoE over failure times, the PPPoE client will need to reconnect
Idle Time: set idle time, idle time at the appropriate time to release the PPPoE
Authentication: including local and Radius (Remote Authentication Dial In User)
Local User Management
（CHAP Secrets）
User: set PPPOE client's user name
Password: set PPPOE client's user password
IP Address: set PPPOE client's user IP address
Enable: enable or disable this setting
Radius