MTX-ROUTER User Manual
Matrix Electronica S.L Page 54 of 87
Add： Alejandro Sanchez 109, 28019 Madrid. ESPAÑA
http：//www.mtx-terminals.com Tel：+34-91.560.27.37 Fax：+34+34-91.565.28.65
Name: to indicate this connection name, must be unique
Enabled: If enable, the connection will send tunnel connection request when it is reboot or
re-connection, otherwise it is no need if disable
Local WAN Interface: local addresss of the tunnel
Remote Host Address: IP/domain name of end opposite; this option can not fill in if using tunnel
mode server
Local Subnet: IPSec local protects subnet and subnet mask, i.e. 192.168.1.0/24; this option can
not fill in if using transfer mode
Remote Subnet: IPSec opposite end protects subnet and subnet mask, i.e.192.168.7.0/24; this
option can not fill in if using transfer mode
Local ID: tunnel local end identification, IP and domain name are available
Remote ID: tunnel opposite end identification, IP and domain name are available
Detection: this part contains configure information of connection detection
Enable DPD Detection: enable or disable this function, tick means enable
Time Interval: set time interval of connect detection (DPD)
Timeout: set the timeout of connect detection
Action: set the action of connect detection
Advanced Settings: this part contains relevant setting of IKE, ESP, negotiation mode, etc.
To Next Page
Loading...