48
[Symptom 2 of treadmill will not start ]
To verify Incline motor function (Test VR value)
[Cause]
If the VR value reading show “0” during Auto Check, will cause 01A0.
[Solution]
1. Please release incline tube (Figure A), and run “Auto check”
2. After start “Auto Check”. Will test the Incline motor VR value. (Figure B)
3. If the value show “0” suddenly during Auto Check process. (Figure C)
4. Will appear “01A0”, and this Incline motor is defective part
(Due to VR value is variable, If the VR has broken circuit, Will show “0” on screen).
7.18 How to test Incline motor function troubleshooting
(Figure A)
(Figure B)
(Figure C)