14
7.1 USING SERVICE MODE
CUSTOM
SETTINGS
DEFAULT OPTIONS DESCRIPTION
Service 1 Display Test Press the ENTER key repeatedly to check each
set of LEDs on the display sequentially.
Service 2 KeypadTest Press any key and the display should show the
corresponding message.
Service 3 Accumulated Distance / Accumulated Time Distance:
Mile 0 - 99999
Kilometer0-160898
Time:
0 - 999999
Manually sets the Accumulated Distance and
Time.
Service 4 CSafe / RF Test Press the ENTER key to test CSAFE. Press the
ENTER key again to test the RF.
Service 5 Error Log Message Shows the last 10 errors. Press and LEVEL UP
and DOWN for 3 seconds to clear the errors.
Service 6 Setting the PCB System Date Data Displays the current time
Service 7 Export and Import Parameter Export parameter : Export all parameter to USB
Import parameter 1: Import parameters to
console without accumulated distance and time
and serial
number.
Import parameter 2: Import parameters to
console Include accumulated distance and time
and serial number.
1. To enter Service Mode, hold the INCLINE DOWN and SPEED DOWN
keys for three seconds until Manager Mode appears on the middle LED
display.
2. Press any DOWN arrow key and Service Mode will appear on the display.
3. Press ENTER once Service Mode is displayed.
4. To scroll between programs in the Service Mode, press any UP or DOWN
arrow key.
5. Press ENTER to modify the program settings once displayed.
6. Press any UP or DOWN arrow key to see value.
7. Press the EMERGENCY STOP to exit Service Mode.
7.2 SERVICE MODE OVERVIEW
CHAPTER 7: SERVICE MODE
To Next Page
Loading...
Need help?
General
