10
7.2 TEST MODE OVERVIEW
CHAPTER 7: SERVICE MODE/TEST MODE
1) To enter Manager Mode, press and hold down the Quick Speed 5 and Quick Elevation 5 keys. Continue to hold down these two keys until
the display reads Manager Mode and hit PAUSE key to enter.
2) To scroll through the list of options in Manager Mode, use the quick key Speed UP and Speed DOWN LEVEL keys. Each of the custom set-
tings will show on the display.
3) To select a custom setting, press the PAUSE key when the desired setting is shown.
4) To change the value of the setting, use the quick key Speed UP and Speed DOWN LEVEL keys.
5) To confirm and save the value of the setting, press the PAUSE key.
6) To exit the setting without saving, press the STOP key.
7) Press and hold the STOP key for 3-5 seconds to return to normal operation.
Group Model Item1 Item2 Default
Value
Values/
Range
Unit Notes
Display T5GT Press the ENTER key repeatedly to
check each set of LEDs on the display
sequentially.
Keypad T5GT Press any key and the display should
show the corresponding message.
C-SAFE T5GT Press the ENTER key to test CSAFE.
Headphone Jack T5GT Press the ENTER key to test the insert
headphone jack counts.
RFID Test T5GT Press the ENTER key to test RFID
hardware and RFID card scan.
ErP T5GT Auto/5/10/30/60 Second Press the ENTER key and choice ErP
time to test ErP function.
To Next Page
Loading...
Need help?
General
