28
10.2 RFID INSTALLATION - CONTINUED
10.2.2 T5x RFID Installation (continued)
1. Stick the foam tape (item #5 in the table) on the UCB in the location that is marked in yellow (Figure A).
2. Stick the absorber (item #4 in the table) on the reader board in the location that is marked in yellow (Figure B).
3. Plug in the Reader board to the UCB and use the 2 screws (item #2 in the table) to fix it (Figure C).
4. Put the antenna board on the front cover of the console. Connect the signal connecting wire (item #3/6 in the table) to antenna board (Figure
D).
5. Put the fixing bracket (item #8 in the table) on the antenna board. Use the three screws to fix it (Figure E).
FIGURE CFIGURE B
FIGURE A
FIGURE E
FIGURE D
CHAPTER 10: SPECIFICATIONS AND ASSEMBLY GUIDE
To Next Page
Loading...
