Matsui DMS2-80 - Page 39

Chapter 4 Preparation for Operation
- 35 -
Step Task
3.1 Hopper inside cleaning
【 Notice！ 】Do not impose extra strength on the cylindrical section more than
necessary.
Open the cylindrical section and check whether there is foreign
particle in.
Lid
Diffuser
Packing a Packing b
Separator
Picture 38
3.2 For the convenience of cleaning, please take out the following extracted parts.
Please clean the powder on the hopper inside surface and the parts with
compressed air or gauze.
Clean separator inner
and out surfaces
Clean the pin surface
Pl
ease
dismantle
the
pin of
diffuser
and take out the diffuser.
Lid
Clean inside
Clean the inner and out
surfaces of diffuser
Clean seal
ring surface
＊Please dismantle the
packing b and separator.
Picture 39