Matsui DMS2-80 - Dehumidifying Rotor Specifications

Chapter 11 Specifications
- 64 -
1.Dehumidifying rotor specifications
Type DMS2- 80 120 170 240
℃
-20(According the change of using condition) Drying air
average dew
point
External condition
Temperature30℃，relative humidity75%(DP+25℃)，
infusing
external air10%
Drying wind
quantity
m
3
/h
80 120 170 240
Drying
temperature
℃
80～130(180)
Parameter RB40-520 RB50-520 RB60-520
Designed wind quantity
(m
3
/min)
1.5 3.0 4.3
Drying blower
Output of electric motor (Kw)
(50/60Hz)
0.9/1.15 1.5/1.75 2.2/2.25
Parameter 170FLJ2-6AS 170FLJ2-6CS
Designed wind quantity(m
3
/min) 0.3 0.4 0.5 0.7
Regenerative
blower
Output of electric motor (Kw)
(50/60Hz)
65/60 85/110
Regenerative
heater
Content Kw
(415V/380V/220V/200V)
2.16/1.83/1.83/1.5
3.39/2.91
/2.91/2.4
4.41/3.69
/3.69/3.1
Appellation Comb rotor
Parameter MZC-200H20 MZC-200H30 MZC-250H20 MZC-250H30
External diameter mm
φ200 φ250
Absorb tower
Height mm 200 300 200 300
Output of electric motor (W) 15 Absorb tower
motor
Decelerate ratio 1/1800
Parameter
φ200×250
φ200×350
Drying filter
Filtering area ㎡
0.6 0.84
Parameter Filedon Regenerative
filter Filtering area ㎡
0.015
Diameter of Drying mm
φ50 φ65 φ90
Glue pipe Cooling mm
φ20
Regeneration mm
φ38
Circulating
Heat transfer area ㎡
0.3 0.4
Cooler
Cooling water temperature ℃
5～32
Cooling water quantity L/min 6 10 15 20
Connecting diameter 3/8 B