Chapter 6 Maintenance
- 44 -
High Temperature Caution
After the unit operation stops, for a while, the hot condition continues.
Wait for maintenance and inspection until the unit gets cold (5 h are a standard in the
nature cooling). And, even if the outside of the unit is cold,
be careful sufficiently because the inside and the dry material sometimes are in hot
condition.
1．Daily maintenance
Maintenance item Description
Confirmation of cooling water
Check cooling water inlet and outlet shown in Figure to see if cooling
water is flowing.
It is recommended to install flow meter for inspection of cooling
water flow rate.
【Caution!】
If cooling water is not flowing, drying dew point temperature does
not go down and causes inadequate drying.
And it may not be set at low temperature.
Cooling water
inlet
Cooling water
outlet
Picture 51
To Next Page
Loading...
