Chapter 8 Troubleshooting
- 52 -
【Notice!】Before check
Set the switch『Run-Stop』to『Stop』，Check after making a breaker
“OFF”, the confirmation in the full stop of the equipment and heating
part temperature's falling to the temperature that doesn't get a burn.
Specified about the malfunction of the following of this chapter.
Malfunction part Contents
Carrying
page
The drying blower does not rotate 53
The blower does overloaded operation and the thermal
relay trips.
54
Dry blower
The air quantity from the blower is small. 55
The change of the dry temperature is large.
55
The drying hot air temperature upper limit alarm occurs. 56
Dry temperature
The drying temperature does not rise or drop. 57
Poor drying The moisture content of resin does not decrease. 58
Temperature controller
The indicator with the PV value of the controller doesn't
display the condition of “ON” in primary power and
pushes the CONTROL ON switch.
59
Power breaker
The power breaker trips. 59
Overheat
The overheat alarm occurs.
59
The thermal setting value of every model.
60
Of the checkpoint and disposing method specified from the next page.
Examine before the repair request.
Yet, as for the removing method of a filter, refer to CHAPTER 6.
Maintenance.
If this method is still not effective, Pleas contact my company for repairing.
To Next Page
Loading...
