Introducing Your New Freezer
Before use
Please read these instructions carefully before using your new Matsui Freezer.
The Freezer is for indoor, domestic use only.
Foot
Location
When selecting a position for your Freezer you should make sure the floor is flat and firm, and
the room is well ventilated with an average room temperature of between 10°C and 43°C. Avoid
locating your Freezer near a heat source, eg. cooker, boiler or radiator. Also avoid direct sunlight
in lean-to’s or sun lounges. If you are placing your Freezer in an out-building such as a garage
or annex ensure that the Freezer is placed above the damp course, condensation will occur on
the Freezer cabinet. This unit is not designed for use in garage or any outside installation. Never
place the Freezer in a wall recess or into fitted cabinets or furniture. When your appliance is
working, the condenser at the back (exposed models) may become hot or alternatively the sides
may become hot (hidden condenser models).
Free Space Requirements
When installing the unit, ensure that 100 mm of free space is left at both sides, 100 mm at the
rear of the unit and 300 mm at the top of the unit. The door can be opened to the right or the
left, depending on which best suits the location. Please ensure there is adequate space for the
door to fully open.
Moving the Freezer
The easiest way to move the Freezer is to tip it backwards just far enough to lift the front feet off
the ground and slowly move it into position.
Cleaning before Use
Wipe the inside of the Freezer with a weak solution of bicarbonate soda. Then rinse with warm
water using a ‘wrung-out’ sponge or cloth. Wash the basket and shelves in warm soapy water
and dry completely before replacing in the Freezer. The external parts of the Freezer can be
cleaned with wax polish. If you require more information refer to ‘Cleaning’.
Basket
Thermostat Control Dial
Drain Cap
Power Indicator
Fot
Side Cover
Power Cord with Plug
Hinge
Handle
Lid
To Next Page
Loading...
