General
All controls on the User Interface are momentary actuators with an illuminated ring
surrounding the actuator. The actuator controls all functions of the UI, (Pre-Infusion, Brew,
Steam, and Water), the illuminated ring around the actuator indicates the state of the
operation.
There are two types of actuators used on the UI, Mechanical and Piezo. Operation is slightly
different for these two types of actuators. Any difference in operation between the
mechanical and piezo actuators will be noted in the instructions. Mechanical actuators will
depress when the center is pushed while Piezo actuators will not. Piezo actuators require a
slight force to register a push different than the Mechanical actuators. Practice is encouraged
prior to daily use with the Piezo actuators.
The illuminated ring has four different indications:
Steady ON: This indicates the function is idle (off).
Steady DIM: Used during the Pre-Infusion and Brew operation. Indicates that half of the
operation is not running. For example, if PI is DIM and Brew is Slow Blink, Brew is
on and PI is off
Slow Blink: This indicates the function is running (on).
Fast Blink: Only used in Menu mode when setting up group options.
All actuators operate in the same manner. If the function is off, (Steady ON), pressing the
actuator will turn the function on (Fast Blink). If on, pressing the actuator will turn the function
off. There is a short delay, (¼ second), required between pushes. Pushing the actuator faster
than this will not register a new push.
Each actuator has two uses, regular operation, and menu (setting options for that group). Uses
of the actuator are detailed in the “Functions” section.
2023 Mavam User Manual V4.53 UC/F Page 11 of 28
To Next Page
Loading...