USER INTERFACE MENU INSTRUCTIONS
Menu Overview
Menu functions allow the user to set or change the operating parameters of the User Interface.
Features available in the menu are listed in order with the Parameter in italics and options
available in parenthesis (). Default option shown in brackets [].
1. CLEAN? [NO], (YES) Selects auto clean cycle if yes.
2. [CELSIUS], (FAHRENHEIT) Selects temperature units.
3. OFFSET [0.0] Sets a hardware offset for the temperature display. NOTE: only set this if
you are sure you know the calibrated temperature of the group. This is set at the factory
and normally does not need to be changed.
4. [MANUAL], (AUTOMATIC) Changes mode between Manual and Automatic.
4.1. If set to MANUAL the remaining steps will be skipped.
5. AUTO PI NO:1 [OFF, BEST, (0 to 360)] Sets the Pre-Infusion mode for Automatic one.
6. AUTO BR NO:1 [0], (0 to 1000) Sets the Brew pulses for Automatic one.
7. AUTO PI NO:2 [OFF, BEST, (0 to 360)] Sets the Pre-Infusion time for Automatic two.
8. AUTO BR NO:2 [0], (0 to 1000) Sets the Brew pulses for Automatic two.
9. EXITING MENU End of menu, returns to Idle.
If there is no activity for thirty (30) seconds the menu function will exit and return to Idle.
The Steam AND / OR Water Actuator is used as an Enter button. On three group machines the
Water actuator is used for the center User Interface Enter button. For ease of display the Steam
Actuator is shown in all illustrations.
2023 Mavam User Manual V4.53 UC/F Page 20 of 28
To Next Page
Loading...