To Next PageTo Next PageWhy is the Maxcess Controller actuator unstable in Automatic mode?
The actuator might be unstable because the System Gain is set too high. Decrease the System Gain. Also, check if the cable connectors are loose and tighten them.
What to do if the Maxcess Controller actuator moves in the wrong direction in Automatic mode?
If the actuator moves in the wrong direction, it might be due to an incorrectly set Guide Polarity. Change the Guide Polarity. Another possible cause is selecting an incorrect sensor mode. Select MANUAL mode, and then verify the correct sensor mode is selected. If needed, press the SENSOR key to select the correct sensor mode.
Why Maxcess Fife Polaris DP-20 actuator does not move in Automatic mode?
If the actuator isn't moving, the System Gain might be set too low. Increase the System Gain.
What to do if Maxcess Fife Polaris DP-20 actuator moves to either end of the stroke in Servo- Center mode?
If the actuator moves to either end of the stroke, the Servo-Center Polarity is likely set incorrectly. Change the Servo- Center Polarity.
General| Display | LCD |
|---|---|
| Input Voltage | 24 VDC |
| Communication | Ethernet |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 70°C |
| Humidity | 95% non-condensing |
