Maxcom MM721 User Manual

12
Charging the Battery 2.2
Note: Use only the original battery included in the set.
Using unauthorized batteries could damage the phone and
will void the Manufacturer’s warranty.
Never plug in the charger, if the back cover is not in place.
To charge the phone:
1. Plug one end of the charger into a power outlet.
2. Plug the other end of the charger into a jack located
at the right hand side of the phone. A message
about charging will appear on the LED display, and
the bars in the battery icon will repeatedly fill to
indicate the ongoing charging process.
3. When the battery is fully charged, unplug the
charger from the power outlet and then disconnect
the cable from the phone.
When the charging process is completed, a message Fully
Charged will appear on the LED display, and the battery
icon will stop blinking while highlighted.
2.2.1 Desktop Charger (Optional)
In case of using a desktop charger, you should first plug
the small end of the regular charger into the jack of the
desktop charger, and then plug the other end in to the
power outlet. To charge the battery, just position the phone
onto the desktop charger with the contacts face into the
base.

Maxcom MM721 Specifications

General

Type	Entry-level phone
Product color	Black
Built-in flashlight	Yes
Subscription type	-
Display diagonal	2.2 \
Display resolution	176 x 220 pixels
Form factor	Bar
Phonebook capacity	500 entries
Personal info management (PIM)	Alarm clock, SOS
Rear camera resolution (numeric)	2 MP
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	4 GB
Standby time	350 h
Cables included	USB
2G bands (primary SIM)	900, 1800 MHz
2G bands (secondary SIM)	900, 2100 MHz
Mobile network generation	3G
Talk time (2G)	4.5 h
Talk time (3G)	2.5 h
Battery capacity	800 mAh
Standby time (2G)	- h

Weight and Dimensions

Depth	12 mm
Width	48 mm
Height	124 mm
Weight	84 g