MAXDATA PLATINUM 100 I - Hardware Requirements; Processor; Memory; Supported Memory Modules

12 PBMAXDATA PLATINUM 100 I M9Server Features
Hardware Requirements
To avoid integration difficulties and possible board damage, your system must meet the requirements
outlined below.
Processor
The mainboard supports one Intel
®
Xeon
®
3400 series processor with up to 95 W Thermal Design
Power (TDP) with 2.5 GT/s.
Memory
The server board supports two memory channels with up to three DIMM sockets per channel. The
minimal memory population is one DIMM in memory slot DIMM_A1. Matching pairs of DIMMs
accross channels is recommended (e.g. DIMM_A2 ‑ DIMM_B2). Within a channel DIMM sockets
with a lower number must be populated before sockets with a higher number.
Supported Memory Modules
• 1.5 V DDR3 DIMMs, registered (RDIMMs) or unbuffered (UDIMMs)
• Mixing of RDIMMs and UDIMMs is not permitted
• The following DIMM and DRAM technologies are supported:
• RDIMMs:
‑ Single, dual and quad rank
‑ x8 DRAM with 2 Gbit technology
‑ DDR3 1333 (only single and dual rank), DDR3 1066 and DDR3 800
• UDIMMs:
‑ Single and dual rank
‑ x8 DRAM with 2 Gbit technology
‑ DDR3 1333, DDR3 1066 and DDR3 800
Optional Hardware
Remote Management Module
The Remote Management Module provides extended functions for server management.
A network card is provided specifically for remote access.