15
Outside Property
Maximum Control recommends installing a Sensing edge in this area
to protect against entrapment between the OPENING gate and wall.
Wall
Wall
Entrapment Area
WIRELESS NOTE: Refer to the
instruction sheet that comes with the
wireless module for wiring and
mounting instructions when using
wireless option.
If a self-supporting post is being used, then sensing edges need to
be installed on EACH side of the post to protect against entrapment
in the OPENING and CLOSING direction of gate travel.
Gate Closed
Gate Closed
OPENING direction
Sensing Edge
OPENING direction
Sensing Edge
CLOSING direction
Sensing Edge
Illustrations not to scale
Sensing Edges
Wall
Wireless
Module
installation
Sensing edge entrapment protection
Outside Property
Inside Property
Inside Property
Install sensing edges to help protect against entrapment during cycling of the gate (entrapment protection).
ONE entrapment protection sensor MUST be installed and connected to “Edge 1 CLOSING direction” on MC-200 motor
controller or operator will NOT function. Entrapment protection sensors MUST be MONITORED 10K NORMALLY CLOSED (N.C.)
TYPE and a GEM-104 module MUST be installed.
OPENING direction
Sensing Edge
Self-Supporting Post
Gate Closed
OPENING direction
Sensing Edge
OPENING
direction
Sensing
Edge
CLOSING direction
Sensing Edge
CLOSING direction Sensing Edge
OPENING
direction
Sensing
Edge
Install along entire edge of
the gate to help protect
against entrapment or gate
hitting a vehicle.
IMPORTANT:
Sensing edges MUST be Monitored 10K Normally
Closed Type and a GEM-104 module MUST be installed. See page 20.
See pages 19-20 for wiring instructions.
OPENING
direction
Sensing
Edge
(Wireless)
Entrapment Area
OPENING Direction
CLOSING Direction
Wireless
Module
Wireless
Module
Wireless
Module
Wireless
Module
MGL-
T
X
2
0
M
on
ito
re
d
G
a
te
Lin
k
M
i
l
l
e
r
Ed
ge
To Next Page
Loading...
