Maxon Intelimax+4G - Serial Port Settings and CSD;PPP Dial Out Commands

Intelimax+4G User Manual
- 93 -
CPU, in which case AT$$TPSW=1 should be configured. After each configuration save
and reboot using AT&W and AT$$RESET.
AT$$TPSW=0 – Triple-plus switching handled by internal module
AT$$TPSW=1 – Triple-plus switching handled by the modem
Serial Port Settings
The follow AT commands are supported in both IP and Serial Modem modes to change
the serial baud rate and flow control:
Baud Rate: AT+IPR
AT+IPR=9600
OK
Flow Control: AT+IFC
AT+IFC=0,0 - no flow control
OK
AT+IFC=2,2 - hardware flow control
OK
CSD and PSD/PPP dial out commands (Serial mode only)
Command
TE2
 
MT2
Command
TE2
 
MT2
ATD<phone_number>
Notify
TE2
 
MT2
CONNECT (Data call connected)
Connect <Speed> if
connect_baud is set. NO CARRIER
(Data call failure)
Value
phone_number:
for Packet Switched Data: *99# (Australia – requires authentication)
for Circuit Switched Data: You will need a data number ( Code 2620
activated on the SIM account)
Notify
TE2
 
MT2
AT: RING
Command
TE2
 
MT2
ATA (answer data call)
Notify
TE2
 
MT2
CONNECT (Data call connected)
CONNECT <SPEED> if connect_baud is
enabled. NO CARRIER (Data call failure)
Call State
Command
TE2
 
MT2
+++ (escape command to go to off-line
command state) ATH (release call)
Notify
TE2
 
MT2
NO CARRIER