Intelimax+4G User Manual
- 94 -
Periodic Reset (Serial mode only)
at$$preset=2
OK
at$$preset?
$$PRESET: 2
OK
To configure periodic reset in IP Stack modes, use the AT$$RESET command
Auto Recovery from CSD/PPP Call (Serial mode only)
The command will set up a time delay for the modem to perform a reboot if there is no
CSD/PPP call is made after the previous call or modem boot up.
The configurable time delay is 1 to 24 hours. If “0” is set, the auto recover will be
disabled.
If auto recover is enabled and there is an incoming CSD call, the modem will perform a
reboot in 20 minutes (non-configurable) if there is no active CSD/PPP Calls.
at$$autocover=2
OK
At$$autorecover?
$$AUTORECOVER: 2
OK
Getting S0 value (Serial mode only)
Please use ATS0? Command to get the S0 value. AT&V command will give you an
incorrect S0 Value:
ATS0=2
OK
ATS0?
2
OK
To Previous Page
Loading...