Maxon MULTIMAX MA 2040 - CLI Introduction and Usage; CLI Hierarchy Levels and Modes

!
MULTIMAX(USER(GUIDE(
67!
!
Transparent: Router will transmit the serial data transparently
without any protocols.
Modbus: Router will transmit the serial data with Modbus
protocol.
t
Mode
@Transparent
Select from “TCP Server”, “TCP Client” and “UDP”.
TCP Client
Local Port
@Transparent
Enter the Local port for TCP or UDP.
0
Multiple Server
@Transparent
Click “Add” button to add multiple server. You need to enter
the server’s IP and port, and enable or disable “Send data to
serial”. If you disable “Send data to serial”, router will not
transmit the data from this server to serial port.
Note: This section will not be displayed if you select “TCP server”
in “Mode”.
Null
Enable
Protocol @Transp
arent
Tick to enable protocol advanced setting.
Disable
Interval Timeout
@Transparent
The serial port will queue the data in the buffer and send the
data to the Cellular WAN/Ethernet WAN when it reaches the
Interval Timeout in the field.
Note: Data will also be sent as specified by the packet length
or delimiter settings even when data is not reaching the
interval timeout in the field.
10
Packet Length
@Transparent
The Packet length setting refers to the maximum amount of
data that is allowed to accumulate in the serial port buffer
before sending. 0 for packet length, no maximum amount is
specified and data in the buffer will be sent as specified by the
interval timeout or delimiter settings or when the buffer is full.
When a packet length between 1 and 1024 bytes is specified,
data in the buffer will be sent as soon it reaches the specified
length.
Note: Data will also be sent as specified by the interval timeout
or delimiter settings even when data is not reaching the preset
packet length.
1360
Enable Delimiter1
When Delimiter 1 is enabled, the serial port will queue the data
in the buffer and send the data to the Cellular WAN/Ethernet
WAN when a specific character, entered in hex format, is
received. A second delimiter character may be enabled and
specified in the Delimiter 2 field, so that both characters act as
the delimiter to control when data should be sent.
Disable
Delimiter1 (Hex) @
Transparent
Enter the delimiter in Hex.
0
Delimiter Process
@ Transparent
The Delimiter process field determines how the data is handled
when a delimiter is received.
None: Data in the buffer will be transmitted when the delimiter
is received; the data also includes the delimiter characters.
Strip