Maxon MULTIMAX MA 2040 - IP Routing, DynDNS, and VPN Setup

!
MULTIMAX(USER(GUIDE(
35!
!
Password,
Dialup No.
3.11 Configuration -> Ethernet
This section allows users to set the Ethernet WAN and LAN parameters.
Eth0/Eth1
Ethernet @ Eth0
Item
Description
Default
Ethernet
Interface Type
Eth0 can work under two different kinds of mode: LAN and WAN.
LAN
Enable Bridge
@ LAN Interface
Enable to make Eth0 works under bridge mode with Eth1. Eth0 and
Eth1 will have the same IP address under this mode.
Enable
IP Address,
NetMask, MTU
@ LAN Interface
Set the IP address, netmask and MTU of Eth0/Eth1. These
parameters will be unconfigurable if you enable Bridge.
Null
Multiple IP
Address @ LAN
Interface
Assign multiple IP addresses for Eth0/Eth1.
Null
Enable DHCP
Server @ DHCP
Server
Enable to make router can lease IP address to DHCP clients which
connect to Eth0/Eth1.
Enable
IP Pool Start, IP
Pool End @
DHCP Server
Define the beginning (IP Pool Start) and end (IP Pool End) of the
pool of IP addresses which will lease to DHCP clients.
192.168.0.2
/
192.168.0.1
00
Netmask @
DHCP Server
Define the netmask which the DHCP clients will obtain from DHCP
server.
255.255.25
5.0
Lease Time @
DHCP Server
Define the time which the client can use the IP address which
obtained from DHCP server.
60
Primary/Second
ary DNS Server
@ DHCP Server
Define the primary/secondary DNS Server which the DHCP clients
will obtain from DHCP server.
192.168.0.1
/
0.0.0.0
WINS Server @
DHCP Server
Define the WINS Server which the DHCP clients will obtain from
DHCP server.
192.168.0.1
Static Lease @
DHCP Server
Define to lease static IP Addresses, which conform to MAC
Address of the connected equipment.
Null