Maxon MULTIMAX MA 2040 - Configuration -> IP Routing

!
MULTIMAX(USER(GUIDE(
39!
!
Protocol
Select from “TCP”, “UDP”, “TCP&UDP”, “ICMP” or “ALL”.
If you don’t know what kinds of protocol of your application, we
recommend you select “ALL”.
TCP
Note: You can use “-“ to define a range of IP addresses or ports, e.g. 1.1.1.1-2.2.2.2, 10000-12000.
Mac-IP Bounding
Mac-IP Bounding @ Firewall
Item
Description
Default
Mac-IP
Bounding
The defined host (MAC) on the LAN side only can use the defined IP
address to communicate with router, or will be rejected.
Null
Mac Address
Enter the defined host’s Mac Address.
Null
IP Address
Enter the defined host’s IP Address.
Null
3.14 Configuration -> IP Routing
This section allows users to set the IP routing parameters.
Static Route
Static Route @ IP Routing
Item
Description
Default
Static Route
Table
Allow users to add, delete or modify static route rules manually.
Null
Interface
Select from “WAN”, “LAN_0” or “LAN_1”.
WAN
Destination
Enter the destination host’s IP address or destination network.
Null
NetMask
Enter the netmask of the destination or destination network.
Null
Gateway
Enter the gateway’s IP address of this static route rule. Router will
forward all the data which fit for the destination and netmask to this
gateway.
Null