Maxon MULTIMAX MA 2040 - Page 94

!
MULTIMAX(USER(GUIDE(
93!
!
INTERFACE MODE:
MA-2040(config)# interface Ethernet 0
MA-2040(config-e0)# ? //check what commands can be used in interface mode
exit Exit from current mode
end Exit to normal mode
ip Set the IP address of an interface
mtu Set the IP address of an interface
5.2 How to configure the CLI
Following is a list about the description of help and the error should be encountered in the
configuring program.
Commands /tips
Description
?
Typing a question mark “?” everywhere needed that will show
us the helpful information.
Ctrl+c
Press these two keys at the same time , except its “copy”
function but also can be used for “break” out of the setting
program .
Invalid command “xxx”
Parameters “xxx” are not supported by the system , in this case,
enter a mark “?” instead of “xxx” will help to find out the
correct parameters about this issue.
Incomplete command
Parameters haven’t been finished yet .
% Invalid input detected at '^'
marker
'^' marker indicates the location where is set wrong .
NOTE: Almost all the parameters to be set are in the Global configuration mode, commands set,
add are very important for this mode. If some parameters can’t be found in the Global
configuration mode, please move back to Privileged exec mode or move up to Interface mode .
NOTICE: Knowing the CLI hierarchy level modes is necessary before configuring the CLI. If
you don’t, please go back and read it quickly in chapter 5 !