Destination IP: packet's destination IP address
Note: "Source Port" ,"Destination Port" ,"Source IP" ,"Destination IP" could not be
all empty ,you have to input at least one of these four parameters.
Serial Applications
The modems serial port is by default a “console” for the modem kernel. By enabling the serial
application, you can assign this port to an application such as UDP to serial gateway, Modbus TCP
device etc.
Serial Applications: enable or disable serial app
Baud Rate: serial port speed
Databit: number of data bits in serial frame (5,6,7 or 8)
Stopbit: number of stop bits in serial frame (1 or 2)
Parity: Parity bit to use (none, odd or even parity)
Flow Control: select none, hardware (RTC/CTS) or software (XON/XOFF)
To Next Page
Loading...
