MRU: Maximum receive unit
NAT: Network address translation
Fixed IP: enable a fixed IP for this client
Fixed IP Address: (when “Fixed IP” is enabled) the fixed IP to use.
Require CHAP: Enable or disable support chap authentication protocol
Refuse PAP: Enable or disable refuse to support the pap authentication
Require Authentication: Enable or disable support authentication protocol
OPENVPN
Start Type: WAN UP----start after on-line, System----start when boot up
Config via: OpenVPN configuration using the server (web page) or a file
(daemon)
Server mode: Router (TUN)-route mode (layer 3 link), Bridge (TAP)----bridge
mode (layer 2 link)
What you see below this option depends on the option you select as below:
Router (TUN):
Network: network address allowed by OPENVPN server
To Next Page
Loading...
