SMS Message Input: for each input (1 and 2) enter the SMS message content to
send when input goes high (“trigger high”) and low (“trigger low”)
SMS Message Output (Relay): for each output, enter the SMS message content
that needs to be sent to the router to set the output on (“trigger high”) or off
(“trigger low”)
Phone Number: Enter up to 6 (six) phone numbers to send status to / receive
commands from. Number should be in international format (eg “+61412345678”)
Digital IO Status: The current state of the 2 inputs and 2 outputs is listed. To
update the web page with current values, click the “Refresh” button
Web Control: Click the “Output 1” or “Relay Output” buttons to toggle the output
to the “opposite” state (ie, if digital out is off, click “Output 1” to change to on, if on
same button will change it to off)
Administration
Management
The Management screen allows users to change the router's settings. On this
page, users will find most of the configurable items of the router code.
The new password must not exceed 32 characters in length and must not
include any spaces. Enter the new password a second time to confirm it.
Note：Default username and password is admin.
To Next Page
Loading...
