WAN
This WAN settings page configures the modems WAN network. Users can
configure modem to get WAN IP address using various options mentioned below.
Some Internet Service Providers (ISPs) will require users to enter specific
information such as User Name, Password, IP Address, Default Gateway
Address, or DNS IP Address. This information can be obtained from your ISP, if
required. This page also has dual link option, WAN NAT and optional settings for
Wide Area network.
For dual SIM devices, there are two sets of parameters, “SIM1” and “SIM2” – the
below descriptions apply to both.
WAN FAILOVER OPTION
This option is for redundancy purpose. When enabled, Backup Wan connection
settings will be displayed with the Main WAN connection and users can configure
backup link accordingly. Once main connection fails, modem will automatically
switch to backup link without any further delay.
NOTE: Keep online detection settings are discussed in the next section.
Connection Type
There are six(6) configuration options for the WAN interface:
Disabled; Wired WAN – Static; Wired Wan – DHCP; dhcp-4G; PPPoE; 3G link -
Dialup
Disabled
The WAN port is not used
To Next Page
Loading...
