of these (eg, channel 1,2 and 3 can’t use “lower”, as there are not channels 3
steps “below” these ones!)
Wireless SSID Broadcast：
Enable
SSID is announced and advertised by the router
Disable
SSID is not advertised – you cannot “browse” this network to connect, you
must know it exists.
Network Configuration：
Bridged：Bridge to the router, under normal circumstances, please select the
bridge. In this mode, WiFi clients and LAN clients appear as one network
segment.
Unbridged There is no bridge to the router, routes need to be manually
configured.
Virtual Interfaces：Click Add to add a virtual interface. Add successfully, click on
the remove, you can remove the virtual interface. By adding a virtual interface, you
can have a WiFi WAN connection and a separate SSID for local clients.
To Next Page
Loading...
