IPSEC
Global settings
You can enable or disable NAT-T and set the debug level here.
Connect Status and Control
Show IPSEC policy and status of current router on IPSEC page.
Name: the name of IPSEC connection
Type: The type and function of current IPSEC connection
Common name: local subnet, local address, opposite end address and opposite
end subnet of current connection
Status: connection status: closed, negotiating, establish:
• Closed: this connection does not launch a connection request to opposite
end
• Negotiating: this connection launches a request to opposite end, is under
negotiating, the connection has not been established yet
• Establish: the connection has been established, enabled to use this tunnel
Action: the action of this connection, current is to delete, edit, reconnect and
enable
To Next Page
Loading...
