5. USING THE POOL CLEANER
5.1 Setup
Before using the Pool Cleaner for
the first time, perform the following
steps:
Position the power supply so that it is
approximately in the middle of the long side
of the pool at a distance of 3m /10ft.
Unwind the cable and stretch it out completely so that
it has no kinks.
Attach the floating cable to the power
supply by inserting it with the notch on the
connector (1), lined up with the groove in
the socket on the power supply, and turning
clockwise (2).
Plug in the power supply and leave it in the
OFF position.
5.1.1
5.1.4
5.1.2
5.1.3
1
2
To Next Page
Loading...
Need help?
General
